Grizzly Slip Roll 16 Gauge G5771 - Manual (Page 18)

-16-
g5771 50" slip roll 16 gauge
3. turn the radius adjust knobs to lift the rear
roller until the desired radius bend is reached
(
figure 19). Make sure to turn the knobs
equal amounts so the rear roller is always
parallel with the other rollers. Failure to do so
will create a larger radius on one end than the
other, resulting in a cone or spiral shape.
8L
figure 19. setting the radius.
2. turn the crank clockwise to feed the workpiece
until its edge is directly above the rear roller,
as shown in
figure 18.
figure 18. Feeding the workpiece.
4. turn the crank to process the material
through the slip roll. Continue turning until the
workpiece is completely through the upper
and lower rollers (
figure 20).
this machine poses a crushing hazard if
workpieces are not properly supported
when exiting the rollers. If necessary, get
assistance to support the workpiece. Make
sure all helpers are wearing safety glasses,
leather gloves, and steel toed footwear
when assisting in the use of this machine.
figure 20. processing the workpiece.
Depending on the size and shape of your
workpiece, you may need assistance to sup-
port the workpiece as it exits the machine.
failure to adequately support the workpiece
may result in the workpiece falling, causing
crushing injuries.