Grizzly Slip Roll 16 Gauge G5771 - Manual (Page 17)

g5771 50" slip roll 16 gauge
-15-
creating bends
the Model g5771 can easily create constant-
radius bends in sheet metal up to 16 gauge.
Note: The method for creating a specific radius is
a trial-and-error process. Due to the many varia-
tions among metal workpieces, no single position-
ing will create the same curve on all materials. We
recommend using scrap pieces the same dimen-
sions and material as your final workpiece until the
desired curve is achieved.
8L
figure 17. raising lower roller.
to create a bend in a workpiece:
1. place the workpiece between the upper and
lower rollers, as shown in figure 17. turn the
thickness adjust knobs to lift the lower roller
until the workpiece is held snug between the
upper and lower rollers. Be sure to turn the
thickness adjust knobs equal amounts.
2. remove the workpiece from between the
rollers, then raise the lower roller slightly by
rotating each thickness adjust knob approxi-
mately
1 ⁄
4
turn. also, make sure the rear roller
is lowered completely and will not interfere
with the workpiece as it exits the machine
(
figure 15).
8L
figure 15. raising lower roller 1 ⁄
4
turn.
figure 16. Flat rolling the workpiece.
3. With the help of an assistant, feed the
workpiece into the rollers while turning the
crank (
figure 16).
approximately
1 ⁄
4
turn.
4. Continue processing the workpiece by repeat-
ing Steps 2 and 3 until the desired results are
produced.
the main rollers of this
machine present a pinch-
ing hazard. Make sure no
body part or clothing is
near the area between the
rollers. failure to follow this
warning may result in fin-
gers, hair, or clothing being
pulled into the machine,
causing personal injury.