FUJITSU T1000 - Manual (Page 75)

49
A P P E N D I X
C
Configuring the Network
Management Port
If your server uses system firmware 6.2 or subsequent compatible versions, do not
perform the following configuration. Your ALOM CMT system controller network
management port is preconfigured at the factory.
If your server uses an earlier version of firmware than system firmware 6.2, you
must configure the network management port before you can use it.
This appendix includes the following topic:
■ Configuring the System Controller Network Manager Port
Configuring the System Controller
Network Manager Port
▼ To Configure the System Controller Network
Management Port
To access the system controller using the network for the first time, you must first
configure the SC network management port through the SC serial management port.
You set these network parameters according to the specific details of your network
configuration:
■ if_network – Specified whether the SC is on the network or not
■ netsc_ipaddr – IP address of the system controller
■ netsc_ipgateway – IP address of the gateway for the subnet