Frymaster H17 - Manual (Page 16)

1-12
9. Remove the contactor mounting screws and
remove the contactor.
10. Install the new contactor and connect the
wiring removed in Step 8.
11. Install the contactor box by following the
previous steps in reverse order.
1.10 Built-in Filter System Service Procedures
Filtration Problem Resolution
One of the most common errors is placing the filter paper on the bottom of the filter pan rather than
over the filter screen.
CAUTION
Ensure that filter screen is in place prior to filter paper placement and filter pump
operation. Improper screen placement is the major cause of filter system
malfunction.
Whenever the complaint is “the pump is running, but no oil is being filtered,” check the installation
of the filter paper, and ensure that the correct size is being used. While you are checking the filter
paper, verify that the O-ring on the bottom of the filter pan is present and in good condition. A
missing or worn O-ring allows the pump to take in air and decreases its efficiency. Also, oil leaks
on the floor each time a vat is drained.
Contactor mounting screws
Mercury Contactor Latching Contactor