FUJITSU T5140 - Manual (Page 70)

54 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
ttya-rts-dtr-off true, false false If true, operating system does not
assert rts (request-to-send) and dtr
(data-transfer-ready) on serial
management port.
ttya-ignore-cd true, false true If true, operating system ignores
carrier-detect on serial management
port.
ttya-mode 9600,8,n,1,- 9600,8,n,1,- Serial management port (baud rate, bits,
parity, stop, handshake). The serial
management port only works at the
default values.
output-device virtual-conso
le, screen
virtual-conso
le
Power-on output device.
input-device virtual-conso
le, keyboard
virtual-conso
le
Power-on input device.
auto-boot-on-error? true, false false If true, boot automatically after system
error.
load-base 0-n 16384 Address.
auto-boot? true, false true If true, boot automatically after power
on or reset.
boot-command variable-name boot Action following a boot command.
use-nvramrc? true, false false If true, execute commands in
NVRAMRC during server startup.
nvramrc variable-name none Command script to execute if
use-nvramrc?
is true.
security-mode none, command,
full
none Firmware security level.
security-password variable-name none Firmware security password if
security-mode
is not none (never
displayed). Do not set this directly.
security-#badlogins variable-name none Number of incorrect security password
attempts.
TABLE 1 OpenBoot Configuration Variables Stored on the System Configuration Card (Continued)
Variable Possible Values Default Value Description