FUJITSU T5140 User Manual
Page 39
Managing Disks
23
1. Start the format utility:
The format utility might generate messages about corruption of the current label
on the volume, which you are going to change. You can safely ignore these
messages.
2. Select the disk name that represents the RAID volume that you have configured.
In this example, c1t2d0 is the logical name of the volume.
# format
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c1t0d0
/pci@0/pci@0/pci@2/scsi@0/sd@0,0
1. c1t1d0
/pci@0/pci@0/pci@2/scsi@0/sd@1,0
2. c1t2d0
/pci@0/pci@0/pci@2/scsi@0/sd@2,0
3. c1t3d0
/pci@0/pci@0/pci@2/scsi@0/sd@3,0
4. c1t4d0
/pci@0/pci@0/pci@2/scsi@0/sd@4,0
5. c1t5d0
/pci@0/pci@0/pci@2/scsi@0/sd@5,0
6. c1t6d0
/pci@0/pci@0/pci@2/scsi@0/sd@6,0
7. c1t7d0
/pci@0/pci@0/pci@2/scsi@0/sd@7,0
Specify disk (enter its number): 2
selecting c1t2d0
[disk formatted]
FORMAT MENU:
disk - select a disk
type - select (define) a disk type
partition - select (define) a partition table
current - describe the current disk
format - format and analyze the disk
repair - repair a defective sector
label - write label to the disk
analyze - surface analysis
defect - defect list management
backup - search for backup labels
verify - read and display labels
save - save new disk/partition definitions