FUJITSU T5140 - Manual (Page 54)

38 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
▼ Reconfigure a Device Manually
The ILOM firmware provides a set Device-Identifier component_state=enabled
command, which enables you to reconfigure system devices manually. Use this
command to mark the specified device as enabled.
1. “Log In to ILOM” on page 2 .
2. At the ILOM -> prompt, type:
Related Information
■ “Devices and Device Identifiers” on page 38
■ “Unconfigure a Device Manually” on page 37
Devices and Device Identifiers
The device identifiers are case-sensitive.
-> set Device-Identifier component_state=enabled
Device Identifiers Devices
/SYS/MB/CMP cpu_number/Pstrand_number CMP (0-1) CPU strand (0-63)
/SYS/MB/CMP n/RISERn/PCIEslot_number CMP (0-1) Riser (0-1) PCIe slot
(0-5)
/SYS/MB/CMP n/RISERn/XAUIcard_number CMP (0-1) Riser (0-1) XAUI
card (0-1)
/SYS/MB/NET network_number Network interfaces (0-3)
/SYS/MB/PCIE PCIe root complex
/SYS/MB/USBnumber USB ports (0-1, located on rear
of chassis)
/SYS/MB/CMPn/L2_BANKnumber CMP (0-1) Bank (0-7)
/SYS/DVD DVD