FUJITSU T5140 - Manual (Page 64)

48 SPARC Enterprise T5140 and T5240 Servers Administration Guide • July 2009
2. To cause the parameter changes to take effect, type:
The system permanently stores the parameter change.
After you disable the ASR feature, it is not activated again until you re-enable it.
Related Information
■ “Disable ASR” on page 47
■ “View Information on Components Affected by ASR” on page 48
■ “Automatic System Recovery” on page 46
■ “OpenBoot Configuration Variables on the SCC” on page 53
▼ View Information on Components Affected by
ASR
● At the -> prompt, type:
In the show /SYS/component component_state command output, any devices
marked disabled have been manually unconfigured using the system firmware.
The command output also shows devices that have failed firmware diagnostics
and have been automatically unconfigured by the system firmware.
Related Information
■ “Automatic System Recovery” on page 46
■ “Enable ASR” on page 47
■ “Disable ASR” on page 47
■ “Unconfigure a Device Manually” on page 37
■ “Reconfigure a Device Manually” on page 38
ok reset-all
-> show /SYS/ component component_state