Furuno GP-36 - Manual (Page 49)

7-9
7.10 User Display Setup
The user display, which appears when the
[DISP] key is pressed several times, may
be either digital data (default display) or the
speedometer display.
Figure 7-14 User displays
The user may choose three items of navi-
gation data to display on each user display.
The default items are battery power, speed
and course.
1. Press the [MENU] key once or twice to
open the menu.
2. Select USER DISP and press the [ENT]
key. The following display appears.
Figure 7-15 USER DISPLAY menu
3. Press the [ENT] key. The following dis-
play appears.
Figure 7-16 User display
selection window
4. Select OFF (no user display), DIGITAL
or SPDOMETER as appropriate and
press the [ENT] key.
5. The cursor is now on the LARGE/TOP
field. LARGE means the center indica-
tion on the digital display; TOP is the
indication below receiver status and time
on the speedometer display. Press the
[ENT] key. The following display ap-
pears.
Figure 7-17 User display choices
6. Select item desired to display and press
the [ENT] key. (SPD: Speed, TTG: Time-
to-go to destination, CSE: Course, ETA:
Estimated Time of Arrival at destination;
RNG: Range to destination, TRIP: Trip
distance, BRG: Bearing to destination,
PWR: Power source voltage)
7. Select the items LEFT/MIDDLE and
RIGHT/LOWER and set their options
like you did for LARGE/TOP, referring
to Figure 7-18 for location of indications.
Figure 7-18 Location of user-selectable
indications on user displays
9. Press the [MENU] key twice to finish.