FUJITSU T5140 - Manual (Page 96)

74 SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008
output-device virtual-
console,
screen
virtual-
console
Power-on output device.
input-device virtual-
console,
keyboard
virtual-
console
Power-on input device.
auto-boot-on-error? true, false false If true, boots automatically after system
error.
load-base 0-n 16384 Address.
auto-boot? true, false true If true, boots automatically after power on
or reset.
boot-command variable-name boot Action following a boot command.
use-nvramrc? true, false false If true, executes commands in NVRAMRC
during server startup.
nvramrc variable-name none Command script to execute if
use-nvramrc?
is true.
security-mode none, command,
full
none Firmware security level.
security-password variable-name none Firmware security password if
security-mode
is not none (never
displayed). Do not set this directly.
security-#badlogins variable-name none Number of incorrect security password
attempts.
diag-switch? true, false false If true, OpenBoot verbosity is set to
maximum
If false, OpenBoot verbosity is set to
minimum
error-reset-recovery boot, sync,
none
boot Command to execute following a system
reset generated by an error.
network-boot-
arguments
[ protocol, ]
[ key=value, ]
none Arguments to be used by the PROM for
network booting. Defaults to an empty
string. network-boot-arguments can be
used to specify the boot protocol
(RARP/DHCP) to be used and a range of
system knowledge to be used in the process.
For further information, see the eeprom
(1M) man page or your Solaris reference
manual.
TABLE A-1 OpenBoot Configuration Variables Stored on the System Configuration Card (Continued)
Variable Possible Values Default Value Description