FUJITSU T5140 - Manual (Page 32)

10 SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008
Note – The network management port is a 10/100BASE-T port. The IP address
assigned to the network management port is a unique IP address, separate from the
main server IP address, and is dedicated for use only with the ILOM service
processor.
▼ To Activate the Network Management Port
1. Connect an Ethernet cable to the network management port.
2. Log in to the ILOM service processor through the serial management port.
See the ILOM user’s guide for instructions.
3. Type one of the following commands:
■ If your network uses static IP addresses, type:
Note – The values of the IP address, IP netmask, and IP gateway are examples. Use
the values that are appropriate for your installation.
-> set /SP/network state=enabled
Set ’state’ to ’enabled’
-> set /SP/network pendingipdiscovery=static
Set ’pendingipdiscovery’ to ’static’
-> set /SP/network pendingipaddress=10.8.31.163
Set ’pendingipaddress’ to ’10.8.31.163’
-> set /SP/network pendingipnetmask=255.255.252.0
Set ’pendingipnetmask’ to ’255.255.252.0’
-> set /SP/network pendingipgateway=10.8.31.248
Set ’pendingipgateway’ to ’10.8.31.248’
-> set /SP/network commitpending=true
Set ’commitpending’ to ’true’
->