Displaying system fault information, To display current valid system faults – FUJITSU T5140 User Manual

Page 68

Text mode
Original mode

SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008

You can use the ILOM set Device_Identifier component_state=enabled command
to reconfigure any device that you previously unconfigured with the
set

Device_Identifier component_state=disabled

command.

Displaying System Fault Information

ILOM software enables you to display current valid system faults.

▼

To Display Current Valid System Faults

●

Type:

This command displays the fault ID, the faulted FRU device, and the fault
message to standard output. The show /SP/faultmgmt command also displays
POST results.

For example:

For more information about the show /SP/faultmgmt command, refer to the
ILOM guide and the ILOM supplement for your server.

-> show /SP/faultmgmt

/SP/faultmgmt

Targets:

0 (/SYS/PS1)

Properties:

Commands:

show