Figure 1-4, Table 1-2 – FUJITSU T5140 User Manual

Page 35

Text mode
Original mode

Chapter 1

Configuring the System Console

FIGURE 1-4

Patch Panel Connection Between a Terminal Server and a SPARC Enterprise
T5140 or T5240 Server

If the pinouts for the serial management port do not correspond with the pinouts
for the RJ-45 ports on the terminal server, you must make a crossover cable that
connects each pin on the SPARC Enterprise T5140 or T5240 server serial
management port to the corresponding pin in the terminal server’s serial port.

TABLE 1-2

shows the crossovers that the cable must perform.

TABLE 1-2

Pin Crossovers for Connecting to a Typical Terminal Server

SPARC Enterprise T5140 or T5240 Serial Port
(RJ-45 Connector) Pin

Terminal Server Serial Port Pin

Pin 1 (RTS)

Pin 1 (CTS)

Pin 2 (DTR)

Pin 2 (DSR)

Pin 3 (TXD)

Pin 3 (RXD)

Pin 4 (Signal Ground)

Pin 5 (Signal Ground)

Pin 6 (RXD)

Pin 6 (TXD)

Pin 7 (DSR /DCD)

Pin 7 (DTR)

Pin 8 (CTS)

Pin 8 (RTS)