FUJITSU T5140 - Manual (Page 65)

Chapter 2 Managing RAS Features and System Firmware 43
▼ To Enable Automatic System Recovery
1. At the -> prompt, type:
2. At the ok prompt, type:
Note – For more information about OpenBoot configuration variables, refer to the
service manual for your server.
3. To cause the parameter changes to take effect, type:
The system permanently stores the parameter changes and boots automatically
when the OpenBoot configuration variable auto-boot? is set to true (its
default value).
▼ To Disable Automatic System Recovery
1. At the ok prompt, type:
2. To cause the parameter changes to take effect, type:
The system permanently stores the parameter change.
After you disable the ASR feature, it is not activated again until you re-enable it.
-> set /HOST/diag mode=normal
-> set /HOST/diag level=max
-> set /HOST/diag trigger=power-on-reset error-reset
ok setenv auto-boot? true
ok setenv auto-boot-on-error? true
ok reset-all
ok setenv auto-boot-on-error? false
ok reset-all