FUJITSU T5140 - Manual (Page 42)

20 SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008
You can now issue system commands and view system messages using your local
graphics monitor. Continue with your installation or diagnostic procedure, as
needed.
If you want to redirect the system console back to the serial management and
network management ports, see
“System Console OpenBoot Configuration Variable
Settings” on page 29 .
Switching Between the Service Processor
and the System Console
The service processor features two management ports, labeled SER MGT and NET
MGT, located on the server’s rear panel. If the system console is directed to use the
serial management and network management ports (the default configuration), these
ports provide access to both the system console and the ILOM command-line
interface (the ILOM service processor prompt), each on a separate channel (see
FIGURE 1-6 ).