FUJITSU T5140 User Manual
Page 90
68
SPARC Enterprise T5140 and T5240 Servers Administration Guide • February 2008
7. Configure the new hard drive.
Type the following command:
For example:
The green Activity LED flashes as the new disk at c1t3d0 is added to the device
tree.
8. Verify that the new hard drive is in the device tree.
Type the following command:
Note that c0t3d0 is now listed as configured.
# cfgadm -c configure
Ap-Id
# cfgadm -c configure c1::dsk/c0t3d0
# cfgadm -al
Ap_Id
Type
Receptacle
Occupant
Condition
c0
scsi-bus connected configured
unknown
c0::dsk/c0t0d0
disk connected configured
unknown
c0::dsk/c0t1d0
disk connected configured
unknown
c0::dsk/c0t2d0
disk connected configured
unknown
c0::dsk/c0t3d0
disk connected configured
unknown
c1
scsi-bus connected configured
unknown
c1::dsk/c1t0d0
CD-ROM connected configured
unknown
usb0/1
unknown empty unconfigured
ok
usb0/2
unknown empty unconfigured
ok
usb1/1.1
unknown empty unconfigured
ok
usb1/1.2
unknown empty unconfigured
ok
usb1/1.3
unknown empty unconfigured
ok
usb1/1.4
unknown empty unconfigured
ok
usb1/2
unknown empty unconfigured
ok
#