Furuno DUAL GPS GP-150-DUAL - Manual (Page 63)

8. MENU SETTINGS
8-11
List
1) Press or to select List to show the
STATION NEAREST list.
FREQ
Station Nearest
MENU : Escape ENT : Enter
: Select
1 320.5kHz
2 320.5kHz
3 316.0kHz
4 320.0kHz
5 288.0kHz
RNG BRG
0.6NM
22.3NM
70.3NM
87.2NM
93.7NM
202 *
244
348
77
110
User Setup No Yes
*: User-programmed station
Figure 8-25
2) Press or to select the station
desired.
3) Press the ENTER key.
4) Press the MENU ESC key.
Programming DGPS user stations
You may program 20 DGPS beacon stations
from which to use in DGPS beacon station
selection. This function is available only
when equipped with the internal beacon
receiver.
Entering new DGPS stations
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
2) Press to select DGPS Station.
3) Press to select List to show the
Station Nearest list.
4) Press or to select USER Setup,
and then press to go to the DGPS
Station (USER) list. While searching
stations, the message “Please wait”
appears. Each page shows six stations.
No. FREQ Rate
DGPS Station (User)
MENU : Escape CLEAR : Erase
: Station No.
Position
01 284.0 200 20 0’N 0 0’W
(kHz) (bps)
02 285.0 200 20 0’N 20 0’E
03 286.0 200 0 0’S 20 0’E
04 287.0 200 20 0’S 20 0’E
05 288.0 200 20 0’S 0 0’W
06 289.0 200 20 0’S 0 0’W
: Edit
Figure 8-26
5) Press or to select No. desired,
which has not been used.
6) Press or to show the Edit window.
Rate
Edit=DGPS station: 18
MENU : Escape ENT : Enter
: Column
Position
200 bps
_ _ _ _’N _ _ _ _ _’W
FREQ _ _ _. _ kHz
: Cursor
Figure 8-27
7) Press or to select Freq, and then
enter frequency of the station, and then
press
. (Setting range: 283.5 to 320.5,
in 0.5 step)
8) Press or to select the baud rate,
100 or 200 bps, and then press .
9) Enter latitude and longitude of the station.
To change N to S or E to W, press .
The message “Are you sure to change?
appears.
10) Press the NU/CU ENT key.
The message “Please wait” appears, and
then the DGPS Station (User) list
appears.
Wrong frequency or position was entered
at step 7 to 9, the beep sounds and the
message “Incomplete Data” appears for
three seconds.
11) Press the MENU ESC key.
Editing DGPS stations
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
2) Press to select DGPS Station.
3) Press to select List to show the
Station Nearest list.
5) Press or to select USER Setup,
and then press to go to the DGPS
Station (User) list.
6) Press or to select the station from
the list, and then press or to show
the Edit window.