FUJITSU FTP604 - Manual (Page 28)

12-02-2003
Page 3-28 of
- 3-28 -
51
Decimal 27 100
[Description] This command will enable that the boards
save values to the flash, this is made to
ensure that a wrong transmission not will
change settings in the board, remember to
send the command “Saving data to board”,
to actual save the data.
3.8.33 Save data to board
[Name] Save data to board
[Format] ASCII ESC e
Hex 1B 65
Decimal 27 101
[Description] This command saves all settings to flash.
3.8.34 Change dot size
[Name] Change dot size
[Format] ASCII ESC f n
Hex 1B 66 n
Decimal 27 102 n
[Description] If n = 0x01, then the board is set to
FTP624MCLxxx.
If n = 0x02 then is it set to FTP634MCLxxx.
The value is saved to flash,
3.8.35 Change form feed length
[Name] Change form feed length
[Format] ASCII ESC g n
Hex 1B 67 n
Decimal 27 103 n
[Description] N represents the value in mm that is form
feeded after the feed command is sent. The
value is saved to flash.
3.8.36 Change baud rate
[Name] Change baud rate
[Format] ASCII ESC h n
Hex 1B 68 n