FUJITSU FTP604 User Manual
Page 27
12-02-2003
Page 3-27 of
- 3-27 -
51
If n > 1 and < 254 then the output will
be turned on in n/4.096msec, and then
turned off again.
If n = 255, then the output will be turned
on.
3.8.29 Automatic sending status
[Name]
Automatic sending status
[Format]
ASCII
ESC a
Hex
1B 61
Decimal 27
97
[Description]
When this command is sent once, then the
board will transmit the status every time that
it change state.
3.8.30 Stop sending automatic status
[Name]
Stop sending automatic status
[Format]
ASCII
ESC b
Hex
1B 62
Decimal 27
98
[Description]
When this command is sent then it will turn
off transmitting status.
3.8.31 Color/Grey scale graphic
[Name]
Colour / Grey scale graphic
[Format]
ASCII
ESC c
n
Hex
1B 63
n
Decimal 27
99
n
[Description]
When this command is sent then will the
board not feed. After the next graphic data
(both compression and not). The n is a
percent of the burn ratio, n can be from 0 to
15, and the burn ratio is 100/15*n. This
command is used by the driver to make
colour and grey scales printout.
3.8.32 Enable saving data
[Name]
Enable saving data
[Format]
ASCII
ESC d
Hex
1B 64