FUJITSU Eturneus Disk Storage System (ISCSI) for VMware ESX - Manual (Page 20)

Chapter 6
Setting Up the VMware ESX Server
This chapter describes settings related to the server iSCSI interface.
6.1 For VMware vSphere
Set up the VMware ESX server using the vSphere Client. The procedures described here are based on the fol-
lowing multipath configuration.
●
For the ETERNUS DX Disk storage system
For example, a total of four IP addresses are required by the following iSCSI connection setup.
Example connection configuration
IP address
for iSCSI port (3) IP address
for iSCSI port (4)
VMware ESX server
VMkernel (iSCSI Software Initiator)
IP address (1) VMkernel (iSCSI Software Initiator)
IP address (2)
LAN card LAN card
LAN switch LAN switch
ETERNUS DX Disk storage system
6.1.1 Turning on the Devices
To turn on the connected devices, use the following procedures:
1 Turn on the LAN switch power.
2 Check that the LAN switch's Ready (or equivalent) LED is lit.
3 Turn on the ETERNUS DX Disk storage system.
4 Check that the Ready LED is lit on the ETERNUS DX Disk storage system.
20
ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware ® ESX
Copyright 2013 FUJITSU LIMITED
P3AM-3412-13ENZ0