FUNAI DRV-B2734 - Manual (Page 64)

64
VC
R
fu
nc
tion
s
EN
Accidental erasure prevention
To prevent accidental recording on a recorded
cassette, remove its record tab. To record on it later,
cover the hole with cellophane tape.
One-touch timer recording
This feature allows you to set the recording length
simply by pressing [REC / OTR].
1
Turn on the unit and insert a
recordable tape.
Make sure that the TV input is set on the unit.
2
Press [VCR ].
3
Select the recording speed using
[REC SPEED] (See page 63.).
4
Select the desired channel to record
using [PROG.
U / D] or [the Number
buttons].
5
Press [REC / OTR] repeatedly until
the desired recording time (30
minutes to 8 hours) appears on the
TV screen.
One-touch timer recording will start.
• When the unit reaches the specified time, it will be
turned off automatically.
• To change the recording length during one-touch
timer recording, press [REC / OTR] repeatedly until
the desired length appears.
• To cancel one-touch timer recording within the
specified time, press [STOP S].
Hint
• The remaining recording time will appear on the TV
screen during one-touch timer recording. Press
[DISPLAY] to see it on the TV screen.
Note
• If VCR one-touch timer recording is completed
during DVD playback or recording, the VCR will be
in stop mode and the DVD keeps the current mode.
• You cannot use the pause function during one-touch
timer recording.
• When one-touch timer recording is finished and the
power is turned off, the unit will switch to the timer-
standby mode automatically if a timer recording has
been programmed. Press [T-SET] to cancel the
timer-standby mode to use the unit continuously.
Search
Index search
1
Press [VCR ].
2
During tape playback, press
[SEARCH] so that the index search
menu appears.
3
Enter the number of recordings you
wish to skip using
[the Number buttons] within 30
seconds.
4
Press [ f] or [r] to start index
search.
If you want to go in the forward direction, press
[
f].
If you want to go in the reverse direction, press
[
r].
After index search, the VCR will play back the
tape automatically.
Note
• Every time a tape is recorded, an index mark is
written on the tape.
Time search
This feature allows you to go to a specific point on a
tape by entering the exact amount of time you wish to
skip in order to reach the point.
1
Press [VCR ].
2
During tape playback, press
[SEARCH] repeatedly so that the
Time search menu appears.
3
Enter your desired time to skip using
[the Number buttons] within 30
seconds.
4
Press [ f] or [r] to start time
search.
If you want to go in the forward direction, press
[
f].
If you want to go in the reverse direction, press
[
r].
After time search, the unit will play back the tape
automatically.
Note
• These functions are not available during recording.
• Press [STOP
S] to stop the search.
• If the tape reaches the end during a Search, this unit
will cancel the search and rewind the tape.
Record tab
VCR VCR
0:30
8:00 7:30
1:00 (Normal Recording)
VCR VCR
VCR VCR
DRV_B2737_B2734.book Page 64 Thursday, March 31, 2005 10:04 PM