FUNAI DRV-B2734 - Manual (Page 31)

31
Reco
rd
ing
EN
• The timer recording cannot be performed in DVD
and VCR at the same time. If you set two
programmings with the same channel and time both
in DVD and VCR, the programming that has priority
will be recorded.
• You cannot make any DVD operation during DVD
timer recording.
• You cannot make any VCR operation during VCR
timer recording.
• If the Start and End times are same, the length of
the recording will be set for 24 hours. If the disc
becomes full during recording, the unit will turn itself
off. To continue recording, press [T-SET] to cancel
the timer stand-by mode, insert a recordable disc
and press [T-SET] again.
• If two or more programmes overlap, “Overlap” and
the overlapped programme number will appear on
the display.
• If the Start time is earlier and the End time is later
than the current time, the recording will start
immediately after you press [T-SET].
• If a videotape ends during timer recording, the unit
will automatically stop, eject the videotape, and turn
itself off. To continue recording, insert a recordable
tape.
Priority of overlapped settings
The unit records programmes according to priority if
timer programmes overlap.
If the starting time is same:
• The timer programming set first (PROG. 1) has
priority.
If programming has been made at the end of the
programming (PROG. 1) currently being recorded:
• The timer programming set first (PROG. 2) has
priority. PROG. 3 will not be recorded.
If the recording time is partially overlapped:
• The timer programming with the earlier start time
(PROG. 2) has priority. PROG. 1 will start after
PROG. 2 recording is complete.
If the recording time entirely overlaps:
• The shorter timer programming (PROG. 1) is not
recorded.
Note for DVD recording
• If the recording time of two programmes overlap, or
the End time of a programme and the Start time of
another is same, the first 30 seconds (at the most)
of the subsequent programme are cut off.
If the End time of the programme currently being
recorded and the Start time of the subsequent
programme are same:
• If PROG. 1 is a DVD recorded programme, the
beginning of PROG. 2 may be cut off.
* If the cut off time exceeds 1 minute, the error
number “E40” will appear in the timer programming
list.
PROG. 1
PROG. 2
PROG. 1 PROG. 2
PROG. 2
recording
will start
after
PROG. 1
recording is
completed.
Actual
recording
Additional 30 seconds (at the most) are cut off
PROG. 1
PROG. 2
PROG. 1 PROG. 2
PROG. 3
PROG. 2
recording
will start
after
PROG. 1
recording is
completed.
Actual
recording
Additional 30 seconds (at the most) are cut off
PROG. 1
PROG. 2
PROG. 2 PROG. 1
Additional 30 seconds (at the most) are cut off
Actual
recording
PROG. 1
PROG. 2
PROG. 2
Actual
recording
PROG. 1
PROG. 2
PROG. 2 PROG. 1
Actual
recording
The first 30 seconds
(at the most) are cut off.*
DRV_B2737_B2734.book Page 31 Thursday, March 31, 2005 10:04 PM