FUNAI DRV-B2734 - Manual (Page 28)

28
Reco
rd
ing
EN
Note
• You cannot use the pause function during one-touch
timer recording.
• The unit will be turned off automatically under the
following conditions.
- No space remains on the disc.
- If a power failure occurs.
• If DVD one-touch timer recording is completed
during VCR playback or recording, the DVD will be
in stop mode and the VCR keeps the current mode.
• When one-touch timer recording is finished and the
power is turned off, the unit will switch to the timer-
standby mode automatically if a timer recording has
been programmed. Press [T-SET] to cancel the
timer-standby mode to use the unit continuously.
Timer recording
You can set the unit to record up to 8 programmes, up
to a month in advance. Daily or weekly programme
recordings are also available.
• Be sure to set the clock before entering a timer
programming.
• You can select the timer programming list by
pressing [TIMER PROG.]. In this case, continue
from step 5.
Insert a recordable disc or a tape with a
record tab.
1
In stop mode, press [SETUP].
2
If you select “Advanced Setting
Menu,” proceed to step 3.
If you select “Easy Setting Menu,”
proceed to step 4.
3
Select “Recording” using
[Cursor
U / D], then press [ENTER].
4
Select “Timer Programming” using
[Cursor
U / D], then press [ENTER].
The Timer Programming list will appear.
5
Select a programme that is not set
using [Cursor
U / D], then press
[ENTER].
6
Enter the date using [Cursor U / D],
then press [Cursor
P].
Each time you press [Cursor D] at the current
date, the timer recording mode will change as
follows.
e.g., 1st January
DVD-RW DVD-RW
Video
DVD-RW DVD-RW
VR
DVD-R DVD-R VCR VCR VCR
Timer Programming
Date Start End CH Speed
2. - - -
3. - - -
4. - - -
5. - - -
6. - - -
7. - - -
8. - - -
1. - - -
PDC
DVD
VCR
VCR DVD
Daily
M-F (Mon.-Fri.)
01/01
31/01
W-SAT
W-FRI
W-SUN
D
D
D
D
D
D
D
DRV_B2737_B2734.book Page 28 Thursday, March 31, 2005 10:04 PM