FUNAI DRV-B2734 - Manual (Page 12)

12
Bef
o
re y
o
u
star
t
EN
Installing batteries in the remote
control
Install two R6 (AA) batteries (supplied) into the
remote control, carefully match with the polarity
indicated inside the battery compartment.
Caution
• Incorrect use of batteries can result in hazards such
as leakage and bursting.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
• Make sure that the plus and minus ends of each
battery match the indications inside the battery
compartment.
• Remove batteries if the equipment will not be used
for a month or more.
• When disposing used batteries, please comply with
governmental regulations or the public instructions
for environmental protection that apply in your
country or area.
• Do not recharge, short-circuit, heat, burn or
disassemble batteries.
About the remote control
• Make sure there is no obstacle between the remote
control and the remote control sensor on the unit.
• Use within the operating range and angle as shown.
• Remote control operation may become unreliable if
the remote control sensor of the unit is being
exposed by the strong sunlight or fluorescent light.
• Remote controls for different devices can interfere
with each other. Be careful when using remote
controls for other equipment located close to the
unit.
• Replace the batteries when the operating range of
the remote control reduces.
VCR / DVD recorder Switching
Because this product is a combination of a VCR and a
DVD recorder, you must select first which component
you wish to operate with [SELECT
L P] on the front
panel.
Press [VCR ] on the remote control.
(Verify that the VCR SELECT indicator is lit.)
Press [DVD ] on the remote control.
(Verify that the DVD SELECT indicator is lit.)
Note
• Pressing only [SELECT L P] on the front panel
DOES NOT switch the mode of the remote control.
You MUST select the correct mode on the remote
control.
• Press [SELECT L P] to select the DVD mode or the
VCR mode.
• You cannot switch to the mode (DVD or VCR) that is
in the timer-standby mode.
• If the media is available, you can start recording by
pressing [REC / OTR] (DVD) or [REC / OTR] (VCR)
on the remote control even if another equipment
(DVD or VCR) is selected. In this case, the mode of
the remote control will be automatically switched to
the appropriate component.
2 1 3
POW ER DISP LAY REC SPE ED CLE AR
CM SKIP SK IP
REC PAU SE P
ENTE R
RE C MO NIT OR OPEN /CLO SE TIME R PR OG .
ME NU PLA Y L IST
TO P M EN U/ OR IGIN AL
SPA CE
1 2 3 4 5 6 7 8 9 0
FW D STO P PL AY RE V
CH .@/: ABC DEF GHI JKL MNO PQR S TUV WXY Z
60˚
Within about
7 m
Remote
control
VCR mode
DVD mode
STANDBY-ON REW FFWD STOP/EJECT PLAY RECORD PROG. DUBBING SELECT STOP PLAY RECORD
SELECT DVD VCR
S-VIDEO VIDEO L(MONO)-AUDIO-R
OPEN/CLOSE
SELECT
SELECT
DVD VCR
DVD SELECT
indicator
VCR SELECT
indicator
DRV_B2737_B2734.book Page 12 Thursday, March 31, 2005 10:04 PM