FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 63)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 63
Resolving the Wrong Ribbon error (being displayed incorrectly) (continued)
Step Procedure
2 Test the Ribbon ID Sensor.
a. Unplug the Printer.
b. Remove the back cover.
c. Flip switches 3 and 4 on the bank of DIP switches in the Main Board
corner.
d. With the top covers closed, apply power to the Printer while holding down
the Pause/Resume button.
e. Once the LCD screen displays RUNNING SELF TEST #12, release the
Pause/Resume Button.
f. Open up the top Print cover.
g. Slowly rotate the supply side of the ribbon. (Note: As the spool is rolling,
the Printer should emit a beep every time a metal pin from the ribbon ID
core passes the Sensor.)
h. Replace the Ribbon ID Sensor if the Printer responds by emitting no
beeps or if one long set of beeps is emitted (regardless of the ribbon
’
s
position).
Resolving the Ribbon Low Message
Symptoms: The Printer beeps just before each ribbon panel is printed. The ribbon is
running low, which indicates the Print Ribbon is running low and that it will soon run out.
When this message is displayed, there should be 10 to 20 additional prints left on the ribbon.
Step Procedure
1 Print until the ribbon is gone and replace the ribbon as needed.