FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 189)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 189
Replacing the Cleaning Tape
The Card Cleaning Cartridge removes dust particles from the top and bottom of a blank card
as it feeds into the Printer. It accomplishes this through two (2) Cleaning Rollers that are in
turn, continually cleaned by a replaceable Card Cleaning Tape.
Caution: Replace this tape to help prevent card contamination for higher quality
output.
Step Procedure
1 a. Replace the Card Cleaning Tape should be replaced approximately every
1,500 prints or as needed depending on the cleanliness of the card stock
and the environment in which the Printer is located.
b. Replace this tape if the cards start showing speckles or debris on the printed
surface.
2 Open the Printer's Print Top Cover and remove the Print Ribbon.
3 Pull the Cleaning Cartridge out of the Printer.
Continued on the next page