FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 187)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 187
Cleaning the Card Feed Rollers
The Card Feed Rollers move the card throughout the print process.
Caution: Clean these Rollers to prevent card jams and card contamination and to
provide better print quality and extended Printhead life.
Step Procedure
1 a. Ensure consistent Printer operation by cleaning these Rollers
approximately every 1,500 prints or as needed depending on the
cleanliness of the card stock and the environment in which the Printer is
located.
b. Clean if the Rollers appear dirty or if the cards start showing speckles or
debris on the printed surface.
c. Refer to Steps 2 to 5 (in this procedure) to clean all these Rollers through
a single, easy process:
2 a. Open the Printer's Top Covers and remove all card, Print Ribbon and over
laminate from the Printer.
b. Leave the Printer power ON and the Top Covers open throughout this
procedure. (Note: The Card Cleaning Cartridge can also remain within
the Printer during this cleaning process.)
3 Get a Cleaning Card from the Printer Cleaning Kit and remove its adhesive
backing paper.
Continued on the next page
Card Feed Rollers