FARGO electronic Pro-LX Laminating Card Printer/Encoder - Manual (Page 4)

RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 4
Safety Messages (review carefully)
Symbol Critical Instructions for Safety purposes
Danger: Failure to follow these installation guidelines can result in death or
serious injury.
Information that raises potential safety issues is indicated by a warning
symbol (as shown to the below).

To prevent personal injury, refer to the following safety messages
before performing an operation preceded by this symbol.

To prevent personal injury, always remove the power cord prior to
performing repair procedures, unless otherwise specified.

To prevent personal injury, make sure only qualified personnel
perform these procedures.
Caution: This device is electrostatically sensitive. It may be damaged if
exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the below).

To prevent equipment or media damage, refer to the following
safety messages before performing an operation preceded by this
symbol.

To prevent equipment or media damage, observe all established
Electrostatic Discharge (ESD) procedures while handling cables in
or near the Circuit Board and Printhead Assemblies.

To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality wrist
strap grounded to avoid potential damage).

To prevent equipment or media damage, always remove the Pro-
LX Ribbon and Cards from the printer before making any repairs,
unless otherwise specified.

To prevent equipment or media damage, take jewelry off of
fingers and hands, as well as thoroughly clean hands to remove oil
and debris before working on the printer.