FMI CCL3018PTA/NTA - Manual (Page 17)

www.fmiproducts.com 124971-01C 17
INSTALLATION
Continued
Figure 20 - Installing Crossover Log #4
(CCL3924PTA/NTA Shown)
Middle
Log (#2)
Back Log
(#3)
Pins
Crossover
Log (#4)
Figure 21 - Installing Crossover Log #5
(CCL3924PTA/NTA Shown)
Crossover
Log (#4)
Front Log (#1)
Crossover
Log (#5)
Crossover
Log (#4)
Front
Log (#1)
Figure 22 - Installing Crossover Log #5
and Log #6 (CCL3018PTA/NTA Only)
Crossover
Log (#5)
Middle
Log (#2)
Crossover
Log (#6)
For CCL3018PTA/NTA Only: Locate
holes on bottom of crossover log (#5).
Slide holes over left pins on middle log
(#2) and front log (#1). See Figure 22.
6. Locate holes on bottom of crossover log
(#6). Slide these holes onto right pins lo-
cated in middle log (#2) and front log (#1).
See Figure 23, for CCL3924PTA/NTA. See
Figure 22 for CCL3018PTA/NTA.
7. Add lava rock around base of heater if
desired. Do not place any lava rock on
logs or burner.
6
Figure 23 - Installing Crossover Log #6
(CCL3924PTA/NTA Shown)
Pins
Middle
Log (#2) Front
Log (#1)
Crossover
Log (#6)