FUJITSU MPG3XXXAH-E User Manual
Page 123
5 - 56
C141-E116-01EN
*3 Status flag
Bit
Description
0
If this bit is set to 1, it indicates the attribute is guaranteed for
normal operation when an attribute value exceeds the threshold.
1
If this bit is set to 1 (0), it indicates the attribute is updated only
by on-line test (off-line test).
2
If this bit is set to 1, it indicates a performance attribute.
3
If this bit is set to 1, it indicates an error-rate attribute.
4
If this bit is set to 1, it indicates an event count attribute.
5
If this bit is set to 1, it indicates the attribute shall be collected and
saved even if the failure prediction feature is disabled.
6 to 15
Reserved bits
*4 Normalized attribute value
The current attribute value is the normalized raw attribute data. The value varies between 01h
and 64h. The closer the value gets to 01h, the higher the possibility of a failure. The device
compares the attribute values with thresholds. When the attribute values are larger than the
thresholds, the device is operating normally.
*5 Worst ever normalized
This is the worst attribute value among the attribute values collected to date. This value
indicates the state nearest to a failure so far.
*6 Raw attribute value
Raw attributes data is retained.