Fortinet FortiGate 60B - Manual (Page 42)

FortiGate-60B FortiOS 3.0 MR6 Install Guide
42 01-30006-0446-20080910
Configuring the modem using the CLI Configuring the modem interface
holddown-timer Used only when the modem is
configured as a backup for an
interface. Set the time (1-60 seconds)
that the FortiGate unit waits before
switching from the modem interface to
the primary interface, after the primary
interface has been restored.
This is available only when mode is set
to redundant.
60
idle-timer Set the number of minutes the modem
connection can be idle before it is
disconnected.
This is available only if mode is set to
standalone.
5
interface Enter an interface name to associate
the modem interface with the ethernet
interface that you want to either back
up (backup configuration) or replace
(standalone configuration).
No default.
mode {redudant |
standalone} Enter the required mode:
• redundant
The modem interface automatically
takes over from a selected ethernet
interface when that ethernet interface
is unavailable.
• standalone
The modem interface is the connection
from the FortiGate unit to the Internet.
standalone
modem-dev1{internal |
pcmica-wireless} Set the modem type for the selected
dialup account.
internal
modem-dev2{internal |
pcmica-wireless} Set the modem type for the selected
dialup account.
internal
modem-dev3{internal |
pcmica-wireless} Set the modem type for the selected
dialup account.
internal
passwd1 Enter the password used to access the
specified dialup account.
No default.
passwd2 Enter the password used to access the
specified dialup account.
No default.
passwd3 Enter the password used to access the
specified dialup account.
No default.
peer-modem1
{actiontec | ascendTNT
| generic} If the modem at phone1 is Actiontec or
AscendTNT, select that type, otherwise
leave setting as generic.
This setting applies to models 50AM,
60M and WiFi-60M only.
generic
peer-modem2
{actiontec | ascendTNT
| generic} If the modem at phone2 is Actiontec or
AscendTNT, select that type, otherwise
leave setting as generic.
This setting applies to models 50AM,
60M and WiFi-60M only.
generic
peer-modem3
{actiontec | ascendTNT
| generic} If the modem at phone3 is Actiontec or
AscendTNT, select that type, otherwise
leave setting as generic.
This setting applies to models 50AM,
60M and WiFi-60M only.
generic
Keywords and variables Description Default