Fitness Quest Brutus 655 - Manual (Page 26)

26
FIGURE 11
FIGURE 11
Step 62.
Step 63.
Step 64.
Step 65.
Step 66.
Step 67.
Step 68.
Step 69.
Push 1” x 2” END PLUGS (73) into ends of LEFT BENCH PRESS FRAME (33).
Push 3/4” BUSHINGS (70) into LEFT BENCH PRESS FRAME (33).
Attach LEFT BENCH PRESS FRAME (33) to LEFT VERTICAL FRAME (5) with 5/8” x 6-3/4”
SHAFT BAR (60), 5/8” WASHERS (65) and 5/8” LOCKNUTS (66).
Lift LEFT BENCH PRESS FRAME (33), insert STOP ROD (35) and lower LEFT BENCH PRESS
FRAME until it rest on STOP ROD.
NOTE: Make sure STOP ROD is locked around LEFT OBLIQUE FRAME (4).
Attach two PULLEYS (76) to LEFT BENCH PRESS FRAME (33) with 3/8” x 5-1/8” HEX BOLT
(58), 3/8” WASHERS (62) and 3/8” LOCKNUT (67).
Attach LEFT PRESS ARM (34) to LEFT BENCH PRESS FRAME (33) with 3/8” x 3” HEX BOLT
(54), 3/8” WASHERS (62) and 3/8” LOCKNUTS (67).
Push 1” ROUND END PLUGS (74) into ends of LEFT PRESS ARM (34) and slide 2” SQUARE
END CAPS (72) over ends.
NOTE: Liquid soap applied to LEFT PRESS ARM (34) will help SHORT FOAM GRIPS (85)
slide on easier.
Slide SHORT FOAM GRIPS onto ends of
LEFT PRESS ARM until flush with end.
73
1” x 2”
END PLUG
33
LEFT BENCH
PRESS FRAME
5
LEFT
VERTICAL
FRAME
70
3/4”
BUSHING
65
5/8”
WASHER
66
5/8”
LOCKNUT
35
STOP ROD
4
LEFT
OBLIQUE
FRAME
60
5/8” x 6-3/4”
SHAFT BAR
66
5/8”
LOCKNUT
65
5/8”
WASHER
85
SHORT
FOAM
GRIP
76
PULLEY
58
3/8” x 5-1/8”
HEX BOLT
62
3/8”
WASHER
67
3/8”
LOCKNUT
34
LEFT
PRESS
ARM
54
3/8” x 3”
HEX BOLT
74
1”
ROUND
END PLUG
62
3/8”
WASHER
62
3/8”
WASHER
67
3/8”
LOCKNUT
74
1”
ROUND
END PLUG
72
2”
SQUARE
END CAP
85
SHORT
FOAM
GRIP