FUJITSU ETERNUSmgr P2X0-0202-01EN User Manual

Page 59

Chapter 6 Messages
>

6.4 Log Messages

ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-

P2X0-0202-04ENZ0

Can't Get File Status "file name" (CODE 903)

[Explanation]Cannot acquire file status.
[Response] Confirm your access permissions to the file and its directory.

Can't Create Socket (CODE 904)

[Explanation]Failed to create a socket.
[Response] Confirm system resources.

Can't Allocate Memory (CODE 905)

[Explanation]Failed to reserve an open area in memory.
[Response] Allocate the necessary memory.

Bad IP Address "host name or IP address" (CODE 906)

[Explanation]The specified target IP address is invalid.
[Response] Set the correct IP address.

Can't Create Directory "path" (CODE 908)

[Explanation]Failed to create a directory.
[Response] Confirm your access permissions to the directory.

Confirm that the name of the specified directory is correct.

Not NULL Parameter "parameter" (CODE 909)

[Explanation]NULL is not allowed for this parameter setting.
[Response] Set the parameter.

Not Find Parameter "parameter" (CODE 910)

[Explanation]This parameter setting cannot be found.
[Response] Set the parameter.

Parameter too long "parameter" (CODE 911)

[Explanation]Too many characters are used in this parameter setting.
[Response] Correct the parameter setting.

Directory Name too long "directory name" (CODE 912)

[Explanation]The directory name is too long.
[Response] Set a shorter directory name.

Bad Parameter (CODE 913)

[Explanation]The "TARGET_FLAG" parameter is either incorrect or not set.
[Response] Correct the "TARGET_FLAG" parameter.

An example of log message output is shown below.