FUJITSU ETERNUSmgr P2X0-0202-01EN - Manual (Page 23)

Chapter 2 Setup
>
2.3 Setting Items
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
23
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
When the Polling Interval and the Alarm Mailing Interval are different:
(Example) Polling Interval: 300 sec. (5 min.) Alarm Mailing Interval: 1200 sec. (20 min.)
■ Mail Server Address (ETERNUSmgr for Windows® only)
This parameter is used to specify the address of the mail server that will receive the E-mail notifi-
cations from ETERNUSmgr.
E-mail notification is then routed to the specified Admin Mail Address by the mail server specified
here.
[Parameter]
ADMIN_MAILSV
[Example]
When the Mail Server Address is "mailsv.domain-name.com".
ADMIN_MAILSV=mailsv.domain-name.com
■ Mail Server SMTP Port (ETERNUSmgr for Windows® only)
This parameter is used to specify a SMTP port No. for the mail server (ADMINS_MAILSV) when
the ETERNUSmgr server is running on Windows®.
[Parameter]
SMTP_PORT (1-65535)
Unless there is some special reason to change this parameter, it is
recommended to keep the default. For this reason the parameter is initially
commented out.
Mail contents
Send mail
Get
information
Polling time 1st time
second
time
third time
fourth
time fifth time
300 sec 1200 sec 0 sec 600 sec 900 sec
1st time
second
time
Activate
information
fault 1
detected
fault 2
detected
Activate
information
fault 1
detected
fault 2
detected
• This parameter is initially commented out.
• Normally, the SMTP port is 25. However, if the SMTP port for the
mail server is other than 25 for some reason, correct this parameter
to match.