beautypg.com

FUJITSU ETERNUSmgr P2X0-0202-01EN User Manual

Page 57

background image

Chapter 6 Messages
>

6.4 Log Messages

ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-

57

Copyright 2009 FUJITSU LIMITED

P2X0-0202-04ENZ0

Send Mail "name@server" (CODE 005)

[Explanation]An E-mail was sent.
[Response] None

Initialize "parameter" (CODE 006)

[Explanation]The values set at start-up are displayed.
[Response] None

Create File "file name" (CODE 007)

[Explanation]A file was created.
[Response] None

Erase File "file name" (CODE 008)

[Explanation]A file was deleted.
[Response] None

Server Status Change (CODE 012)

[Explanation]There has been a change in the target device’s status.
[Response] If the component that caused the problem is included in the message, login to

the target device and check the status of that component.

When "No hardware error detected." is displayed, there is no need to do
anything. Detection of the offline status is indicated when "No hardware
report detected. (Offline)" is displayed. In this case, check for problems with
the target device, failures in the communications route, and errors in the
setup file.

Work files create to "temp directory" (CODE 014)

[Explanation]ETERNUSmgr has created a work file in the directory indicated in this

message.

[Response] None

Warning Messages for Parameter Settings (CODE 1XX)

Bad Parameter "parameter" (CODE 102)

[Explanation]This parameter setting is invalid.
[Response] Correct the parameter setting.

Undefined Parameter "parameter" (CODE 103)

[Explanation]This parameter setting is not recognized.
[Response] Correct the parameter setting.

Parameter too long "parameter" (CODE 104)

[Explanation]Too many characters are used in this parameter setting.
[Response] Correct the parameter setting.

Not NULL Parameter "parameter" (CODE 105)

[Explanation]NULL is not allowed for this parameter setting.
[Response] Set the parameter.