FUJITSU ETERNUSmgr P2X0-0202-01EN - Manual (Page 19)

Chapter 2 Setup
>
2.3 Setting Items
ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
19
Copyright 2009 FUJITSU LIMITED
P2X0-0202-04ENZ0
[Default value]
TARGET_PORT = 80
(TARGET_ADDR must be set. There is no default.)
[Parameter]
TARGET_ADDR (up to 64 characters)
TARGET_PORT (0-65535)
[Example]
TARGET_ADDR=127.0.0.1 or TARGET_ADDR=host-name.domain-name.com
TARGET_PORT=80
■ Polling Interval
This parameter is used to control polling (periodically checking the status) of a target device.
Set the polling interval in units of seconds within the range of 1 ~ 65535.
[Default value]
300
[Parameter]
POLLING_TIME (1-65535)
[Example]
POLLING_TIME=300
This specifies the Polling Interval (time between the start of one poll to the next).
Due to network or device load the actual polling time may exceed the set time. In such cases, the
start of the next polling time is delayed until the previous polling finishes:
When the actual polling finishes within the scheduled polling time:
• As the default port number is normally used, the target port parameter is
initially commented out.
• If the target address is changed, the target address must also be
changed in the top menu ("menu.htm").
150 sec 150 sec 150 sec 200 sec
300 sec 300 sec 300 sec 300 sec
Per schedule Per schedule Per schedule
Scheduled polling
interval
Actual polling
interval
Scheduled start OK