Furuno FR-2125V - Manual (Page 30)

2-8
Leading cables into the display unit
The cable clamp may be positioned within the display unit (default arrangement),
outside the display unit or at the bottom of the display unit (when using console
mount, for example). When the cable clamp is located outside or beneath the dis-
play unit, use the bottom clamp front plate and bottom clamp rear plate (supplied
with installation materials).
Also, use the shielding foam (supplied) to guard against noise.
Cable fed from rear of display unit (Default method)
Pan-head screw
M4X8
Hex bolt
M5X12 SUS,
2 pcs
Hex bolt
M5X35 SUS,
2 pcs
Hex bolt
M5X35 SUS,
2 pcs
(A) Rear clamp
base
(B) Power clamp
(Aluminum)
(C) Signal clamp
(Aluminum)
(D) Rear clamp
plate
(B) Power clamp
(Aluminum)
(C) Signal cable
(Aluminum)
(D) Rear clamp plate
(A) Rear clamp base
Cable position in clamp
(Display unit, rear view)
PWR
ANT
Log
Keyboard
Navigation
Nav equipment
(Gyrocompass)
Slave display
External CRT
Rear cable entrance
Cable
Shielding foam
(Display unit, right-hand side view)
(Display unit, rear view)
(Construction of
cable clamp)
Make sure foam contacts rear chassis.
Figure 2-10 Default cable clamp position
• Place shielding foam between cables, and then attach foam to aluminum clamps.
• Fill unused clamp holes with shielding foam.