FUJITSU MCP3130SS User Manual

FUJITSU Hardware

This manual is related to the following products:

MCM3130SS MCP3064SS MCM3064SS

Table of contents

Document Outline

Front Cover
FOR SAFE OPERATION
Revision History
Preface
Important Alert Items
MANUAL ORGANIZATION
REFERENCED STANDARDS
Contents
- Illustrations
  - FIGURES
  - TABLES
CHAPTER 1 General Description
- 1.1 Features
- 1.2 Configuration of Optical Disk Drive
CHAPTER 2 Specifications
- 2.1 Specifications of Optical Disk Drives
- 2.2 Specifications of Optical Disk Cartridges
- 2.3 Defect Management
  - 2.3.1 Defect management schematic diagram
CHAPTER 3 Installation Requirements
- 3.1 Environmental Requirements
- 3.2 Mounting Requirements
- 3.3 Power Supply Requirements
- 3.4 Connection Requirement
CHAPTER 4 Installation
- 4.1 Notes on Drive Handling
- 4.2 Connection Modes
- 4.3 Settings
- 4.4 Mounting
  - 4.4.1 Checks before mounting the drive
  - 4.4.2 Mounting procedure
- 4.5 Cable Connections
- 4.6 Operation Confirmation and Preparation for Use after Installation
  - 4.6.1 Confirming initial operations
  - 4.6.2 SCSI connection check
- 4.7 Dismounting Drive
CHAPTER 5 Operation and Cleaning
- 5.1 Operation of Optical Disk Drive
- 5.2 Cleaning of Optical Disk Drive
- 5.3 Operation of Optical Disk Cartridge
- 5.4 Cleaning the Optical Disk Cartridge
  - 5.4.1 Cleaning tool for optical disk cartridge
  - 5.4.2 Cleaning of optical disk cartridge
CHAPTER 6 Diagnostics and Maintenance
- 6.1 Diagnostics
- 6.2 Maintenance Information
  - 6.2.1 Maintenance requirements
  - 6.2.2 Revision number
CHAPTER 7 SCSI BUS
- 7.1 System Configuration
- 7.2 Interface Signal Definition
- 7.3 Physical Requirements
  - 7.3.1 Interface connector
  - 7.3.2 Interface cable
- 7.4 Electrical Requirements
- 7.5 Timing Rule
- 7.6 Bus Phases
- 7.7 Bus Conditions
  - 7.7.1 ATTENTION condition
  - 7.7.2 RESET condition
- 7.8 Bus Sequence
Glossary
Acronyms and Abbreviations
Index
READER’S COMMENT FORM
Back Cover