FUJITSU MCP3130SS - Manual (Page 163)

Index
C156-E228-02EN IN-3
logical specification type setting 3-24
lower power consumption 1-2
low noise 1-3
M
maintainability 1-3
maintenance 6-1
information 6-2
requirement 6-2
MESSAGE 7-5
phase 7-36
MESSAGE IN phase 7-36
MESSAGE OUT phase 7-36
MCM3130SS current waveform (+5 VDC)
3-14
mean time between failure 1-3, 2-6
mechanical section 1-7
media interchangeability 1-2
mounting 4-12
frame structure 3-12
procedure 4-13
requirement 3-4
MPU 6-1
MSG 7-5
MTBF 1-3, 2-6
multi-host 4-5
N
no overhaul 1-3
noise filter 3-16
notes on drive handling 4-1
O
ODD side 7-6
opening shutter 5-11
operability 1-3
operation 5-1
confirmation and preparation for use after
installation 4-14
of optical disk cartridge 5-6
of optical disk drive 5-1
optical disk cartridge 2-8
optical disk drive
(without panel) 1-6
(with panel) 1-6
front view (with panel) 5-1
order number 2-1
outer dimension 3-4 to 3-9
P
packing 4-2
packing list for cleaning kit 5-10
packing style
individual 4-3
gathered 4-3
panel 1-8
parameters used for synchronous data
transfer 7-35
performance 1-1
phase control 7-27
physical requirement 7-6
placing setting case cover 5-12
positioning error rate 2-5
positions of setting terminal and switch 4-5
power on/off sequence 3-14, 3-15
power requirement 2-4
power supply
requirement 3-14
cable 3-20
connector 3-16
for terminating resistor 7-12
to SCSI terminating resistor 3-16
power switch off setting 3-17
precaution 5-2, 5-9
on mounting 3-12
on use and storage of cleaning kit 5-11
pre-idle mode 4-40
preventive maintenance 6-2
procedure 4-15
R
radio wave standard 1-4
RAM 6-1
random/sequential read test 6-2
read-ahead cache feature 1-4
recommended components for connection
3-20
recommended optical disk cartridge 2-7
reliability 1-3, 2-6
removing optical disk cartridge 5-4
representative model name 2-1
REQ 7-5
REQUEST 7-5
requirement for terminating resistor power
supply 7-12
RESELECTION phase 7-24