Furuno NAVNET 1752C - Manual (Page 50)

2. RADAR OPERATION
2-16
.250/ 319.9
°
M .125nm
SP
H-UP
EBL1
(Dotted line)
EBL2
(Dashed line)
EBL2 bearing
Active marker is highlighted.
+
359.9 ° R
0.24nm
EBL1 bearing
R: Relative
T: True
EBL
VRM
EBL1
330.1
°
R
VRM1
-.---nm
EBL2
234.1 ° R
VRM2
-.---nm
EBL1
ON
VRM1
ON
OFFSET
EBL2
ON
VRM2
ON
How to measure bearing with the EBL
Note: Bearing can be shown Relative to ship’s heading (relative) or in reference
to North (True). This setting may be changed by changing the EBL
REFERENCE setting, which is in the RADAR DISPLAY SETUP menu.
See the paragraph “5.2.1 Radar display setup.”
2.11.3 Erasing an EBL, EBL indication
Press appropriate EBL soft key and press the [CLEAR] key. The EBL is erased
and its indication becomes blank.
2.11.4 Erasing EBL/VRM data boxes
Press the EBL or VRM soft key associated with the EBL/VRM data box you wish
to erase. Press the [CLEAR] key once or twice to erase the data box.
2.11.5 Hiding EBL/VRM data boxes
Press the ZOOM & D. BOX and D. BOX ON/OFF soft keys to show or hide the
EBL/VRM data boxes.
2.11.6 Moving EBL/VRM data boxes
When an EBL/VRM data box is obscuring a target that you need to see, you can
move it to another location as shown below. This cannot be done when the
EBL/VRM soft keys are shown.
1. Press the [EBL/VRM] key to erase the EBL/VRM soft keys if appears.
2. Using the cursor pad, place the cursor inside the data box you wish to move.
As the cursor enters the box it changes to a “hand.” Push the [ENTER] knob,
and the hand changes to a fist, meaning the data box is correctly selected.
3. Use the cursor pad to drag the data box to the location desired and push the
[ENTER] knob.