Furuno NAVNET 1752C - Manual (Page 20)

1. OPERATIONAL OVERVIEW
1-6
1.2 Inserting a Chart Card
Your unit reads FURUNO and Nav-Charts ™ (NAVIONICS), or C-MAP chart
cards, depending on its specifications. Insert the appropriate chart card for your
area as follows:
1. Open the chart card slot lid.
Chart slot
Display unit
2. Insert desired chart card groove side up.
3. Close the lid to protect the chart drive.
Note 1 : Do not insert or remove the chart card while turning power on. This may
cause the equipment to freeze.
Note 2 : Do not remove a card while the chart is being drawn. This may cause
the equipment to freeze.
Note 3 : A card remover is supplied to ease removal of chart cards. Attach the
card remover to the right-hand side hole on the card and pull to remove
card. You can leave the card remover attached to the card while the
card is in the card slot - push the card remover leftward until it contacts
the recessed area in the card.
Note 4
: For multiple display units, do not use the same chart card type in more
than one display unit.
Chart card and card remover