Furuno NAVNET 1752C - Manual (Page 124)

3. PLOTTER OPERATION
3-40
6. Choose how to record points for your route, by time, by distance or manual
entry pressing by one of BCKTRK TIME, BCKTRK RANGE or MANUAL soft
key as appropriate. For manual go to step 8. For BCKTRK TIME, BCKTRK
DIST one of the following displays appears.
TIME INTERVAL
0 0h01m
(When selecting BCKTRK TIME.)
DISTANCE INTERVAL
0 0.1nm
(When selecting BCKTRK DIST.)
Displays for entry of time, distance interval
7. Enter interval desired with the cursor pad and [ENTER] knob. Press the
START LOG and RETURN soft keys followed by the [MENU] key to close the
menu. At this moment, voyage based route will be created.
8. For manual entry of waypoints, do the following:
a) Press the [SAVE/MOB] key momentarily to enter a waypoint mark at own
ship position. A new waypoint is created under the next consecutive
waypoint number and that waypoint is added to the route. (You may close
the SAVE ROUTE screen by pressing the RETURN soft by followed by
the MENU key.)
b) Repeat step a) as necessary. 35 waypoints may be entered.
To stop recording waypoints and save the route
You can stop recording waypoints and save the route at any time as shown in
the procedure below. When 35 waypoints have been entered the message “Total
35 WPTS have been already registered in the route. Stop creating voyage based
route.” is displayed. In this case, automatically creating voyage-based route
stops.
1. Press the [MENU] key followed by the WAYPOINTS/ROUTES and CREATE
VOYAGE-BASED ROUTE soft keys.
2. Press the FINISH LOG soft key to stop recording waypoint and save the
route.
3. Press the [MENU] key to close the menu.