Furuno NAVNET 1752C - Manual (Page 174)

5. CUSTOMIZING YOUR UNIT
5-2
Contents of general menu
Item Description Settings Default Setting
Key Beep Turns key operation beep on/off. On, Off On
Language Chooses menu language. English, French, German,
Italian, Portuguese, Spanish English
Range Unit Chooses unit of range and speed measurement. nm, kt; km, km/h; sm, mph; nm
& yd, kt; nm & m, kt; km & m,
km/h; sm & yd, mph nm, kt
Temperature Unit Chooses unit of water temperature measurement. ° C, ° F ° F
Depth Unit Chooses unit of depth measurement. ft, m, fa, PB (Passi/Braza) ft
Temperature
Source Chooses source of water temperature data. ETR (network sounder), NMEA NMEA
Depth Source Chooses source of depth data. ETR, NMEA. NMEA
Reset Trip Log Resets distance run. Yes, No No
Speed Source Chooses source of own ship’s speed data. ETR, NMEA NMEA
Lat/Lon Display Chooses how many digits (or seconds) to display
after decimal point in latitude and longitude
position. DD ° MM.MM’, DD ° MM.MMM’,
DD ° MM.MMMM’,
DD ° MM’SS.S”
DD ° MM.MMMM’
TD Display Chooses TD type. Loran C, Decca Loran C
Speed Chooses speed format to display. SOG (Speed over ground),
STW (Speed through water) SOG
Position Display Chooses position display format. LAT/LON, TD LAT/LON
Time Display Chooses time notation. 12 hours, 24 hours 24 hours
Infrared Remote
Mode A remote controller can be set exclusively
for use with a specific display unit, in the
case of multiple NavNet display units. For
further details see the Installation Manual. A, B, C, D A
Range & Bearing
Mode Chooses how to calculate range and bearing.
Rhumb Line: Straight line
drawn between two points on a
nautical chart.
Great Circle: Shortest course
between two points on the
surface of the earth. Rhumb Line
Bearing Readout Chooses bearing display format for course, course
over ground and cursor bearing.
True, Magnetic
Magnetic
Magnetic
Variation The magnetic variations for all areas of the earth
are preprogrammed into this unit. The
preprogrammed variation is accurate for most
instances, however you may wish to manually
enter a variation. For manual input, select Manual,
hit the EDIT soft key, enter value and hit the
ENTER soft key to finish. “AUTO” requires position
data. Auto, Manual
Auto
Display Mode
(Monochrome
model) Reverses background (black) and foreground
(white) colors. Day, Night Day
* Select ETR to show water temperature/depth data fed from the network sounder, and then set the TEMP
and DEPTH CALIBRATION of the SENSOR SETUP in the SOUNDER SYSTEM SETUP menu.