Furuno NAVNET 1752C - Manual (Page 218)

6. DATA TRANSFER
6-10
10. Press the RCV soft key to receive data.
The message “START RECEIVING DATA VIA NETWORK.” is displayed. IF
no data could be found the message “(HOST NAME)’ IS NOT FOUND.”
appears.
11. When the transfer is completed, the message “DATA TRANSFER
COMPLETED. PUSH ENTER KNOB TO CONTINUE.” appears. Push the
[ENTER] knob.
12. Press the [MENU] key to close the menu.
6.5 Outputting Data Through the Network
Follow the procedure below to output data through the network.
1. Press the [MENU] key to open the menu.
2. Press SYSTEM CONFIGURATION, SYSTEM SETUP, PORT SETUP and
OUTPUT THROUGH NETWORK soft keys.
SELECT
SNTNC
ON/OFF
RETURN
SELECT SENTENCE
AAM
APB
BOD
BWR
DPT
GGA
GLL
GTD
MTW
RMA
RMB
RMC
VHW
VTG
WPL
XTE
ZDA
HDT
HDG
MWV --
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
--
Select sentence menu
3. Select sentence with the cursor pad.
4. Press the ON/OFF soft key to turn sentence on or off.
5. Press the RETURN soft key.
6. Press the [MENU] key to close the menu.
AAM: Waypoint arrival alarm, APB: Autopilot sentence B, BOD: Bearing origin to
destination, BWR: Bearing and distance to waypoint - rhumb line, DPT: Depth,
GGA: Global positioning system(GPS) fix data, GLL: Geographic position -
latutude/longitude, GTD: Own ship information-TD, MTW: Water temperature,
RMA: Recommended minimum specific LORAN-C data, RMB: Recommended
minimum navigation information, RMC: Recommended minimum specific
GPS/TRANSIT data, VHW: Water speed and heading, VTG: Course over ground
and ground speed, WPL: Waypoint location, XTE: Cross-track error, measured,
ZDA: Time and date, HDT: Heading true, HDG: Heading, deviation and variation,
MWV: Wind speed and angle