Furuno NAVNET 1752C - Manual (Page 198)

5. CUSTOMIZING YOUR UNIT
5-26
WAAS SETUP
Press the WAAS SETUP soft key to show the WAAS SETUP display.
Note:
This function requires GP-320B antenna. Also, confirm that your display
unit has the program version no. shown below.
NavChart type: Ver. 12 and after
C-map type: Ver.8 and after
Contents of WAAS SETUP menu
Item Description Settings Default setting
WAAS MODE Select ON to use the WAAS mode. On, Off Off
WAAS SEARCH WAAS satellite can be searched
automatically or manually. For manual
search, select MANUAL here, and enter
the satellite number (s). Auto, Manual Auto
WAAS ALARM When the positioning mode is changed
from WAAS to GPS, the audible alarm
sounds with the visual message “NO
WAAS SIGNAL.” This audible alarm type
can be changed here.
On: Alarm continues to sound until the
WAAS positioning mode is available again
or the alarm is recognized by key
operation.
Off:
Alarm sounds three times.
On, Off Off
CORRECTION
DATA SET Selects the type of message for WAAS
correction. Use setting “02” until the
system becomes operational, which should
be in 2003. 00 to 27, 99 02
Note:
If the message “NO POSITION DATA!” appears, it means an error occurs
on GPS-310B/320B. Disconnect GPS cable from the display unit.