Freedom9 IP 800 - Manual (Page 35)

freeView IP 800 User’s Manual
entered once to access the console, this value will be set to “CONSOLE ON”. Remember to
set it to “CONSOLE OFF” again if you want to lock it after closing the console. Also, if the
current CONSOLE is ON state and you reset KVM switch, the CONSOLE will set the ON
state back to OFF state.
• When you finish setting the system name and exit the OSD mode, you will find the active
system name displayed at the top-left corner of monitor. You can press the key to clear
the message right away if you don’t need it.
• If you want the OSD to return back to factory default value, you can enter the key
combination , , . The seven segment Bank LEDs on the front
panel will flash during the refresh process.
• When the OSD value is back to default settings, the seven segment Bank LEDs on the front
panel will stop flashing.
5.8 Logging In And Logging Out
5.8.1 Logging In
Launch the web browser and enter the address of the freeView IP 800 in the Address Bar. The
address used can be an IP address or a host and domain name, in the case where the DNS
server has a symbolic name. For example, type the following in the address line of the web
browser when establishing an unsecured connection:
http://
When using a secure connection, type in:
https://
The login page will be displayed (Figure 5-2).
33