Freedom9 IP 800 User Manual

Page 20

Text mode
Original mode

freeView IP 800 User’s Manual

Using a 10 Mbps Connection

For 10BASE-T Ethernet networks, the Ethernet adapter uses Category 3, 4, 5 or 6 UTP cable. To
establish a 10 Mbps connection, the cable must be connected to a 10BASE-T hub.

• Make sure that the cable is wired appropriately for a standard 10BASE-T adapter.

• Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s

connector.

Using a 100 Mbps Connection

For 100BASE-TX Fast Ethernet networks, the freeView IP 800 supports Category 5 or higher
UTP cabling. To establish a 100 Mbps connection, the cable must be connected to a
100BASE-TX hub or switch.

• Make sure that the cable is wired appropriately for a standard 100BASE-TX adapter.

• Align the RJ-45 plug with the notch on the adapter’s connector and insert it into the adapter’s

connector.