Freedom9 IP 800 User Manual

Page 29

freeView IP 800 User’s Manual

• 7-Segment BANK LED Indication

When you would like to view the next bank KVM switch, please press the “BANK“ push button
cyclically until you reach the destination bank. The bank LED will be changed from bank 1 to the
maximum daisy chain level and then press cycle back to bank 1.

Bank 1 Bank 2 Bank 3 MAX. BANK

• Reset Button ((“

Bank ” button) and (PC 8 “

” button)):

Bank

Press both the “Bank” button and any one of the “PC1~PC8” buttons of the master bank
simultaneously to reset the KVM switch. This reset action will not only return the KVM switch
back to its initial state, verify the password and also rescan all of the slave banks which
connected to the master KVM Switch.

If you add a new unit as a slave bank, use the reset button of master unit to automatically assign
a new ID to it. You can view this new slave bank by going through the OSD menu. The PC ports
of the unit are not reset by using the reset command.

• Keyboard Hot Key Commands:

You can control the KVM switch by switching ports using simple key sequences. To send
commands to the KVM switch, the () key must be pressed twice
within 2 seconds. You will hear a beep for confirmation and the keyboard is change to hot key
mode. If you do not press a key in hot key mode within 2 seconds (i.e. pressing a key after
pressing the key twice), the keyboard will go back to the Operation System (OS)
control state.

Below are the different hot key commands for the local KVM:

within 2 seconds

+ + = Previous Channel

Scroll
Lock

↑

+ + = Next Channel

Scroll
Lock

↓

Note: Hold down the direction key to quickly cycle through the ports.