Harman-Kardon HA160-0004-A - Manual (Page 54)

Operation
50
Signature 2.0
The tuner will search upward through the FM band,
automatically examining each station to see if it is send-
ing RDS data and looking to see what the PTY is. When
the next FM station that meets the search criteria is
tuned, the scan will stop and the station will be tuned. If
no station is found that matches the desired PTY type
after a complete scan of the FM band, the tuner will
return to the last station tuned.
Tuner Menu
In addition to using the direct access controls described
above, it is possible to program the tuner functions
and enter presets using the Tuner Menu. This
enables you to quickly set the tuner memory, and it
is a method of tuner operation to consider during the
initial configuration of the 2.0.
The Tuner Menu also allows you to give FM stations
personalized names and Program Types even
if they do not transmit RDS data.
To reach the Tuner Menu, the tuner must first be
selected as the input source. Press the Tuner button g
or select the tuner using the front panel Source
Selectors 3 if the tuner is not already in use.
Press the Menu button j to display the Setup
Menu (Figure OSD-33). The Tuner > line will
be highlighted.
Figure OSD-33
Note that this line does not appear on the Setup
Menu (Figure OSD-1) when the tuner is not selected
as the input source. Press the › Menu Control
button i to display the Tuner Menu. The menu
will differ depending on the frequency band in use.
One menu will appear when an FM station is currently
S e t u p M e n u
T u n e r >
R e c o r d O u t p u t s >
S o u r c e s >
S p e a k e r S e t u p >
A d v a n c e d S e t u p >
tuned (Figure OSD-34), while a different, shorter menu
(Figure OSD-35) will appear when an AM station is
currently tuned.
Figure OSD-34
Figure OSD-35
The first line on both Tuner Menu screens is the
Preset memory function. If a station currently
tuned already has been assigned a preset memory
location, a number will be shown on this line. While
this line is highlighted you may also change to another
preset station by pressing the ‹ or › Menu Control
buttons i until the desired station is tuned. You may
also assign a new preset on this menu, but before doing
that it is necessary to proceed with the other entries on
this menu page and then return to the PSet line. When
you are finished with any change on this line, press the
¤ Menu Control button i to move to the next line.
The RDS line enables you to determine if RDS data
will automatically be displayed when the tuner detects
RDS data on a station’s transmissions or to alternatively
display information manually entered using the ID
and Type lines of this menu Press the ‹ or › Menu
Control buttons i to select from one of the
following choices.
T u n e r M e n u
P S e t : 0 1
F R E Q : 1 0 7 0
B A N D : A M
T u n e r M e n u
P S e t : 0 1
F R E Q : 8 9 . 9
B a n d : F M
R D S : A u t o
I D : K X X X - F M
T y p e : P U B L I C
T y p e S e a r c h >