Harman-Kardon HA160-0004-A - Manual (Page 48)

Operation
44
Signature 2.0
When you have finished this adjustment, press the Surr
button p again to enter the setting and return to nor-
mal operation. Remember, the setting is temporary and
will be canceled as soon as you switch to another mode
or when the 2.0 is turned off.
Display Status Report
With the flexibility of the 2.0, you may occasionally
want a quick reference as to what is playing through the
system. The Display function allows you to view a
report on the current system status at any time.
When the Display button x is pressed a status report
will appear on your video monitor (Figure OSD-16) that
shows the current input source, surround mode and
volume level. If no Dolby Digital (AC-3) information is
being received at the selected input, a “No AC-3
Info ” message will be displayed, (Figure OSD-14),
even when an analog surround mode is selected.
A “No Video Present” message will appear when
there is no active video signal at the selected video input
that accompanies this input source profile.
When the tuner is in use, pressing the Display button
x will show the current station’s frequency and preset
number, if any, in addition to the surround mode,
volume level and input name (Figure OSD-24).
Figure OSD-24
If the RDS system is in use and the station is transmitting
data, it will also be shown when the Display button
x is pressed (Figure OSD-25). See page 48 for complete
information on the RDS system.
T u n e r P S e t :
S t e r e o 1 0 6 . 7 F M
V o l 1 0
N O V I D E O P R E S E N T
Figure OSD-25
Pressing the Display button x when the tuner is in
use will also change the front panel Information
Display so that the input name (e.g., “Tuner”) and
the current surround mode are shown (Figure FPD-10)
instead of the standard tuner display of preset number
and station frequency (Figure FPD-11).
IMPORTANT NOTE: Unlike most on-screen messages
displayed by the 2.0, status screens that appear when
the Display button x is pressed will not “time-out”
and disappear after the time length entered during the
setup procedure (see page 35). To remove this display
from the screen you must press the Display button x
again to return to normal operation.
When a Dolby Digital source is playing, additional
information under the “AC-3 Info” banner will
be displayed to provide some insight into the details
of the source material (Figure OSD-26).
Figure OSD-26
NOTE: This data is not available when a DTS source
is playing.
V i d e o 1 V o l
D o l b y D i g i t a l 1 0
A C - 3 I n f o
P G M C o n t e n t 3 / 2 . 1
M a t r i x E n c o d e d N o
S a m p l e R a t e 4 8 k H z
D a t a R a t e 3 8 4 k b / s e c
T u n e r P S e t : 0 4
M u s i c 1 9 1 . 5 F M
V o l 1 0 K X X X - F M
P U B L I C
T O P L E D G E C A L L 8 0 0 -